How To Clean Raw Wood After Sanding
Always see to it that you will be sanding along the wood grain.
How to clean raw wood after sanding. While blowing the dust off with compressed air removes the dust it also mixes it into the air so some of it can settle back onto the surface and so you can breath it. It is good to use a shop vac to clean the surface between sanding grits removing the larger grit particles from the wood before sanding with the next higher grit. Now heres the secret to protecting and finishing raw wood while also protecting the raw wood look.
Sanding against it might cause irremovable scratches on the surface. The next step is the trick here. Wipe the surface thoroughly with a a wet cloth.
Since its water-based it needs to be applied over raw wood or other water-based products. It has been a woodworkers tool for a long time. Always Remove Dust After Sanding.
Wipe With Denatured Alcohol Many woodworkers end the wood preparation step with the tack-cloth wipe-down but for the very best results conclude your preparation by wiping down the surfaces with a clean cloth moistened with denatured alcohol. Once youre done sanding your woodwork there may be some residue left over. In order to remove the last remnants of the old finish then you must use a medium grit sandpaper.
Use a good vacuum and then a tack rag to wipe the surface clean of any contaminants. Soak a soft rag into the virgin mineral spirit and wipe the floor to clean the dust. If you seek a perfect finish make sure the tack cloth glides smoothly over the wood as you wipe.
Then switch to fine sandpaper 200 grit until the entire piece is uniform. This is usually a dust-like material. The mineral spirit evaporates fast without posing any threat to the wood.