How To Make A Wood Turning Tool Sharpening Jig

Now turn the grinder on and lower the tool onto the wheel.

How to make a wood turning tool sharpening jig. Take the Coach Bolt nut with the end removed and place it on the hole on the hill tilting side. Learn how using a jig when sharpening your woodturning tools allows you to sharpen your tools consistently reduces the amount of material removed. This clamping knob is used to hold and tool that will be sharpen into place.

Turn the grinder on and lower the tip of the parting tool onto the moving grinding wheel for a few seconds. Turn the parting tool over and do the opposite side for the same amount of time. This is a must-have tool for sharpening all your lathe tools.

Tormek SVS-38 Short Tool Jig - Sharpen Short Woodworking Tools like Short Wood Chisels Carving Gouges Tools for Power Carvers etc. 600 mm of 30mm steel angle - needs to be cut into 4 x 30mm 4 x 45mm 1 x 230mm. Ad Find Deals on Products in Power Tools on Amazon.

The Multi-Jig For Sharpening Skew Chisels Gouges Beading Tools and More. Ensure that the raptor tool touches the wheel at two points and is resting firmly in the wolverine jig. If you do it yourself allow some extra length for the 30mm square and angle due to the cutting blade thickness.

The jig produces razor-sharp tools. The end result should be the point of the parting tool be ground to a sharp squared of point. Now I glue a piece of plywood to the bottom.

Place the studding nut and washer to tighten the grip. Place the clamping knob at the top of the wood. I cut the notches by tilting my table saw wheel to 45 degrees and cranking it down as low as it would go.