How To Sharpen Carbide

Keep your chain out of the dirt when cutting or it will dull quickly.

How to sharpen carbide. Sharpening a carbide tipped blade helps to retain the blade in good condition and working order. People stand on the side of the grinder to prevent the fragments from flying out to hurt people when the grinding wheel is broken. Each tooth should be ground on the top face and sides and each tooth has multiple angles that must match and be ground precisely the same.

Re-sharpen your chain every time you refill your chainsaw with fuel. Its also not difficult to maintain the carbide chainsaw chain because carbide is carbide. Turn the bench grinder on and set it to low speed.

The distance between the two hands holding the knife is released and the two elbows are clamped at the waist to reduce the shaking when grinding the knife. The sawtooth sharpening of carbide saw blade is mainly for the back supplemented by sharpening the front and there is no special requirement for tooth side. You can do this by letting it soak in a container full of warm water and some citrus oil soap.

Prior to sharpening it make sure to clean it properly. If the depth gauges are too high the cutters cant reach the wood. I show how to us the Trow and Holdens Diamond Carbide Sharpening System with a die.

Many people choose carbide chainsaw chains for many reasons. You are not finding any specks of illumination over the edge. Sharpening carbide cutting tools can be done with a silicon carbide grinding wheel do not use aluminum oxide.

Apply the wetted paddle hone tip to the flat steel sides of your carbide saw blade re-wetting the tip if sparks occur. If even one or two teeth are off by. Attach a diamond-grinding wheel to an electric bench grinder.