Which Scroll Saw Blade To Use

My rule of thumb is to use a 5 or 7 blade for 34 19mm to 1 25mm-thick medium-hard wood such as cherry walnut or maple.

Which scroll saw blade to use. Basically scroll saws come with two types of blades like pinned and unpinned. The blade of the scroll saw is much finer and narrower than a jigsaw blade or a bandsaw blade. Be sure you will get the best out of more than 4000 used machines and tools.

Here are the steps for how to use a scroll saw. The work moves around the blade on a table instead of the saw moving over the work. Which Scroll Saw Blade To Use Scroll Blade Compatibility.

The blade is flat and is pinched between the jaws of small clamps on the scroll saw. Utilize a 2 or 3 sharp blade for wood that is about 18 in 32 mm thick. A reciprocating saw blade is only attached on one side.

Plain-End blades The plain end blades are quite common as they are safer to use. With this configuration the blade is threaded through a cut in the table and the saw will power the blade to move up and down. And you place the new blade direction wise.

Scroll saws are designed to accept one of two types of blades. These are plain-end blades and pin-end blades. Another number youll frequently see listed for saw blades is the width.

Plain-end blades are the generic types. Using a spiral blade in your scroll saw allows you to push and pull your material in any direction to cut without having to turn or spin your work on the saw table to find the cutting edge. For example a blade with 8 TPI cuts faster than a blade with 12 TPI however there is more control with a blade that has 12 TPI.